GM International D5016DK I.S. SIL3 2-Wire Active HART® Tx Current Repeater

GM International D5016DK I.S. SIL3 2-Wire Active HART® Tx Current Repeater

SKU: GMI20250137
Manufacturers: GM International

$ 538,74

excl. 19% VAT , plus (National)

Available immediately
Delivery time: 24 - 26 Workdays (Other countries)

Description

FEATURES

SIL 3 / SC 3
Input from Zone 0/Div. 1
Installation in Zone 2/Div. 2
4-20 mA Source-Sink Output
HART® compatible
High Accuracy
Three port isolation, Input/Output/Supply
High Density, two channels per unit

STATUS

ACTIVE

CHANNELS

Technical Data

Supply
Voltage	24 Vdc nom (18 to 30 Vdc), reverse polarity protected
Current Consumption	31 mA @ 24 Vdc with 20 mA out, typical.
Power Dissipation	1.80 W @ 24 Vdc with 20 mA output on 250 Ω load and 24 Vdc output supply for sink models, typical.
Input
Type	4 to 20 mA (separately powered input, voltage drop ≤ 7 V), reading range 0 to 22 mA.
HART Impedance	225 Ω, typical.
Output
Type	4 to 20 mA.
Sink out voltage range	2 to 30 V.
Load range	0 to 500 Ω, with conventional Tx input 250 Ω nom (160 to 500 Ω), with smart Tx input.
Current limitation	24 mA (up to 450 Ω load) ≤ max current ≤ 26 mA.
Response time	20 ms (10 to 90 % step change).
Performance
Ref. Conditions	24 V supply, 250 Ω load, 23 ± 1 °C ambient temperature.
Calibration accuracy	≤ ± 20 μA.
Linearity accuracy	≤ ± 20 μA.
Temp. influence	≤ ± 2 μA/°C.
Isolation
Test Voltage	I.S. In/Out 2.5 kV; I.S. In/Supply 2.5 kV; I.S. In/I.S. In 500 V; Out/Supply 500 V; Out/Out 500 V.
Environmental conditions
Operating temperature	temperature limits –40 to +70 °C.
Storage temperature	temperature limits –45 to +80 °C.
Safety description
Equipment	Associated apparatus and non-sparking electrical equipment.
Safety parameters	Uo = 8.8 V, Io = 0 mA, Po = 0 mW at terminals 7-8, 9-10 Ui = 30 V, Ii = 100 mA, Ci = 1.1 nF, Li = 0 nH at terminals 7-8, 9-10
Mounting
Type	DIN-Rail 35 mm, with or without Power Bus or on custom Term. Board.
Weight	about 135 g
Connection	by polarized plug-in disconnect screw terminal blocks to accommodate terminations up to 2.5 mm² (13 AWG).
Dimensions	Width 12.5 mm, Depth 123 mm, Height 120 mm.